1. Cover the outlet holes with Tape to prevent ink loss during refilling.

2. Open the plastic plug fixed in the filling hole carefully. Through this filling hole the correct ink can be injected using a syringe.

3. Attach the needle to the syringe and fill with the correct color ink.

4. Slowly inject approximately 13 ml. of Black Ink or 6 ml of Color Ink slowly into the filling hole until the chamber is almost full. Unused ink may be returned to the bottle.

5. Seal the hole using any sealant gum or tape

6. Remove the tape from the outlet holes.

7. Set above a paper towel for an hour as a drip precaution. Expect a few drips until the vacuum stabilizes.If it looks like the dripping doesn't stop, then the filling hole has an air leak and is not sealed well.

8. After the dripping has stopped, replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions

If necessary leave cartridge in printer for up to 24 hours.
Note: Refill Immediately any empty cartridges.
Your Kit : 3 Syringes for Color with blunt needles, 1 Syringe for Black with blunt needle